This is a table with the region map texture. Scale 1/100 except height wich is 1/500. What it makes is showing small figures representing the avatars within the sensor reach of the system.
When an avatar is detected, the figure is shown in the same position and rotation as the avatar it represents, moving in the same way as the avi by the whole sim.
If you touch the top side of the figure you can check its profile or you can be teleported to the position where that avatar is.
This is a curious and funny alive model showing what happens in our sim. It matches any decoration and attracts attention of the visitors.
When you buy a Sim Model Live you get a box, you have to touch it to transfer its content to a folder inside your inventory named Sim Model Live.
The box contains, the table named Sim Model Live (copy - 2 prims), a sensor (copy + modify - 1 prim) named People Finder, a Landmark and this and other notes.
The sensor (People Finder) can be used in two different ways:
In both cases the sensor has a 96 meters reach radius.
Before starting the system you have to decide the spot or spots from where the sensor will be working in case of static use, or the coordinates of the circuit in case that you use it to cover the full sim.
Once you haven those locations clear you can rez the sensor, it is a metallic ball. If you are going to use it from a static spot put it there and then touch the ball, it shows a menu, click "Static", it will become invisible and starts working. If you are going to use more than one sensor repeat these steps.
If you want to use a mobile sensor, rez the sensor, edit it (right click on it, then edit) go to the content tab and open the note "setup". In that note you have to write the coordinates of the circuit spots, one coordinate per line, including the symbols < and >. The note has 4 coordinates by default, which are ok for sims with no montains and a ground height of around 22 meters. You can change those coordinates by your own. The People Finder, while in the "Full Sim" mode, stops in these spots and from there it makes a scan sweep looking for avatars, then it continues to the next spot in the circuit. When you are ready save the note, close the edit window and touch the sensor. Click on the "Full Sim" button, the sensor starts moving to the first position and becomes invisible.
When you are finished with the sensor or sensors, take the table (Sim Model Live) out of the inventory, put it in the right place but DON'T ROTATE IT, ROTATION MUST ALWAYS BE 0,0,0. Touch the surface, a new menu will come up with different options:
These other options below are also shown after starting the system.
If you touch the map by accident and the menu comes up, press button Start to close it.
The recommended steps sequence to follow is this; first touch the Map button to retrieve the map picture, then choose one of the three figures (Armless, Stick or Figure), last click Start.
This menu is always available for the Sim Model Live owner.
Visit us in world -> Terra Toulouse/196/48/32
You can also buy our products in the Marketplace